replacing printer consumables
Operator’s Guide 25
note
If
toner is spilled, use a toner vacuum to
clean up the loose toner
. Do not use water
to clean the toner from the printer
. Any
toner remaining on clothes can be removed
with a cloth dampened in cold water; never
use hot water to remove toner from clothes
or skin. Use care when handling toner
.
Do not turn off the printer during a print job
to add toner; otherwise, all unprinted data
will be lost. Once the toner is added and
the cover is closed, press ON LINE to
continue printing.
When the toner is low, the printer will
stop and the LCD will show:
Refer to the adjacent figure and perform
these steps:
1 Raise the top of the printer by firmly
pressing the button on the left of the
front panel.
2 Open the toner bottle and attach the
spout.
3 Carefully open the developer unit
cover.
caution
Do
not squeeze the toner bottle as you
pour the toner
. Doing so could cause the
loose toner to be blown out of the
hopper and contaminate the printer and
soil hands and clothes. If the toner
bottle does not empty completely
, gently
tap the end of the bottle while holding it
over the hopper
.
4 Carefully
pour the toner into the
developer unit. Make sure to spread
the toner evenly from side to side.
Developer Unit Cover
(shown in the open position)
T
oner Bottle
(with spout
attached)
03 ADD TONER AND
CHK WASTE BOTTLE
