Media Requirements
Operator’s Guide 11
The printer requires continuous form
media with 0.5 inch pitch tractor feed pin
holes. The media capabilities and
requirements are listed in the following
table:
Dimension
Specification
Width 4.0 to 10.0 inches edge to edge
(3.5 to 9.5 inches pin to pin)
Length 3.0 to 33.0 inches
in 1/8 or 1/6 inch increments
Weight
Labels:
Face Stock
Carrier
Adhesive
18 to 42 lb. bond
110 lb. tag stock
99 lb. card stock
40 to 60 lb. book stock
50 lb. book stock
acrylic
Cut to Tie (page perf)
≥ 2.9:1 (8 cuts/inch) bond (and microperf)
≥ 6.5:1 (4 cuts/inch) tag/card stock
≥ 6.5:1 (4 cuts/inch) label stock
Percent Recycled paper 20% maximum
Moisture Content 5% + 1%
Resistivity 10
8
to 10
12
ohms
note
Bond
paper weight based on 17 X 22 inch
base size. T
ag stock based on 24 X 36 inch
base size. Card stock based on 22 1/2 X 28
1/2 inch base size. Book carrier stock
based on 25 X 38 inch base size.
