A SERVICE OF

logo

FINAL DRIVE 12-67
Rear Final Gear Case
Install (alternately):
Friction Plates [A]
Steel Plates (P/No. 41080-1484, without holes)
Install:
Steel Plate [A] (P/No. 41080-1483, two holes)
Insert the pins [B] into the holes of steel plate.
Install:
Dowel Pins [A]
New Gasket [B]
Tighten:
Torque - Gasket Screws [C]: 1.3 N·m (0.13 kgf·m, 11 in·lb)
Install:
Rear Final Gear Case Front Cover [A]
Tighten:
Torque - Rear Final Gear Case Front Cover Bolts [B]: 24
N·m (2.4 kgf·m, 17 ft·lb)
Inspect:
Ball Bearing [A] (see Bearing and Oil Seal section)
Oil Seal [B] (see Bearing and Oil Seal section)
If they are damaged, replace them.
Apply grease to the oil seal lips and O-ring [C].
Install:
Shim [D]
Ring Gear [E]