A SERVICE OF

logo

10-22 CRA NKSHAF T/TRANSMISSION
Transmission
Remove:
Circlip [A]
Special Tool - Outside Circlip Pliers: 57001-144
Remove:
Spacer [A]
Idle Gear Assembly [B]
Washers and S pacer [C]
Low and High Gears [D]
Remove:
Needle Bearings [A]
Remove the driven shaft [B] from the crankcase using a
press.
Transmission Installation
Insert the driven shaft i n the crankcase until it is bottomed
usingapress.
Apply engine oil to the needle bearings and install them.
Install the following parts on the low gear [A].
Needle Bearings [B]
Spacer [C] (P/No. 92026-1599, 48.2 × 54.3 × 1.0)
High Gear [D]