6-24 CONVERTER SYSTEM
Driven Pulley
•
Align the paint mark “0” [A] on the movable sheave [B]
with the point [C] on the fixed sheave [D] for phase fit of
the sheaves.
○
In that case the opening [A] and hole [B] will be matched
easily.
•
Apply grease WR500-No.2 (KYODO YUSHI), POWER
LITE WR #2 (KYO DO YUSHI), or SERAN-HV (TOTAL
FINA) to the seating surface [A] of the pins, and insert
them into the holes in the movable sheave.
•
Draw the movable sheave onto the fixed sheave, and ap-
ply grease of 1 g ( 0.035 oz) to all openings [A].
Grease - WR500-No.2 (KYODO YUSHI) or
POWERLITEWR#2(KYODOYUSHI)or
SERAN-HV (TOTAL FINA)
NOTE
○
Do not heap up the grease out of the openings.
•
Check that the O-rings [A] are in good condition.
If any of the O-rings are damaged, replace them.
•
Apply grease to the O-rings.
