A SERVICE OF

logo

12-30 FIN AL DRIVE
Front Axle
Remove the steel balls [A].
Slide the cage [B] toward the center of the axle.
Remove:
Circlip [A]
Special Tool - Outside Circlip Pliers [B]: 57001-144
Remove the inner race [A] using a suitable bearing re-
mover [B].
Remove the inboard joint boot [C].
Inboard Joint Boot Installation
Wind the tape on the splines of the axle shaft in order to
protect the joint boot.
Install:
New Small Band [A]
New Inboard Joint Boot [B]
Cage [C]
Install the inner race [A] s o that the flat side [B] faces
outboard joint.