A SERVICE OF

logo

12-60 FIN AL DRIVE
Rear Axle
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
Hold the axle at this setting.
Standard Length of Assembling:
Inboard: 174.6 mm (6.87 in.) [A]
Open the edge of the boot in order to eqalize the air pres-
sures.
Tighten the large band [A].
Assemble it the same as the outboard joint boot, noting
this setting;
Maximum Outside Diameter of Band: 79.7 mm (3.14 in.)
(After tightening the outside diameter)
While the band is held at the diameter above, tap down
the tangs [A] of the band.