EN Configuring the computer interface 87
4
Note
For rows one to three, the page count is incremented after every ten
pages. Row four is incremented after every end of page. Rows one
to four are counted through the engine. Rows five and six are driver
requests.
The tray count is incremented based on the tray that is selected by
the firmware, not the tray that is selected by the user.
Media size count is incremented based on the media size that is
selected by the user. Media type count is incremented based on 1)
the media type that is selected by the user when the media is pulled
from Tray 1; and 2) the media type configured on the tray when media
is pulled from Tray 2 or Tray 3.
Fuser mode count is incremented twice for duplexed sheets, once
when the front side is fused and once when the back side is fused.
15 Calibration density settings—On the bottom row of text, there are
four separate blocks of numbers. The first block is for cyan, second
for magenta, third for yellow, and the last is for black. Make sure the
numbers are not near zero (if so, no calibration was done).
Note
Do not print the configuration page until the printer is ready or
calibration will not occur.
www.GovTechMedia.com
