EN Control panel messages 41
1
62 NO SYSTEM
Indicates there is a printer firmware problem. Either there is no
firmware DIMM installed or the DIMM has failed. If the formatter was
just replaced, make sure all DIMMs have been moved from the old
formatter to the new one.
1 Turn the printer off and on to reset the printer.
2 Reseat the firmware DIMM, making sure it is in the slot surrounded
by a white line with the text “ROM ONLY IN THIS SLOT.”
62.X PRINTER ERROR
Indicates that a problem exists with the internal memory.
X = Description
0 = Internal memory
1-3 = DIMM slots 1 through 3.
1 Turn the printer off and on to reset the printer.
2 Reseat and then replace the DIMM.
3 Replace the formatter board.
62.M BAD MPTR
The firmware ran out of memory trying to build the static entity
directory.
1 Check printer settings to determine which values have been
changed.
2 Clear the message by pressing [Go].
68 NVRAM ERROR
CHECK SETTINGS
One or more settings saved in the non-volatile storage device are
invalid. Some settings might have been reset to factory defaults.
1 Check printer settings to determine which values have been
changed.
2 Clear the message by pressing [Go].
www.GovTechMedia.com
