EN Control panel messages 21
1
REMOVE PAPER TOP OUTPUT BIN
The top output bin holds 250 sheets of paper. Sensor PS9 along with
its sensor flag detects the height of the output paper stack. Perform
the action items if this message appears with no paper in the output
bin.
1. Verify that the PS9 sensor flag and arm move freely and its
movement is not blocked.
2. Verify PS9 is free of dust and debris (top assembly cover must be
removed to access sensor).
3. Verify all connectors are firmly seated. Refer to the wiring diagram.
Note
PS9 (a three-wire sensor) plugs into a through-wall connector on the
printer’s chassis and then into a 14-pin wire harness, which plugs
into J206 on the developing PCB. All signals from the developing
PCB are routed to J201 on the developing PCB to J1017 on the DC
controller PCB.
RESETTING MEMORY
The printer is executing a memory reset. The printer returns to the
READY state upon completion of this process.
RESETTING VALUES FINISHED
The color calibration density values have been reset to their default
values.
RESTORING FACTORY SETTINGS
The printer is executing a RESTORE FACTORY SETTINGS or a
COLD RESET.
No action is required.
www.GovTechMedia.com
