5. System Setup
37
5.8. Beep
The Beep function allows you to control audible
beeping.
1. Follow the instructions in General Procedures
to display the Setup/Help screen.
2. Click on the Beep icon and wait for the Beep
window to pop up.
Figure 5.9: Beep
3. Click on the ON option for audible beeping
or click on OFF to mute it.
4. Click on OK to save your configuration and
exit or click Cancel to exit without saving
changes.
5.9. Touch
The Touch function allows you to calibrate the
touch screen.
1. Follow the instructions in the General
Procedures on page 33 to display the
Setup/Help screen.
2. Click on the Touch icon and wait for Touch
screen to pop up.
3. Click on the center of the target and briefly
hold the stylus pen.
4. Repeat the action as the target moves around
the screen.
5. Tap the screen to register saved data. To exit
without saving changes, simply wait for 30
seconds.
NOTE: Only use the supplied stylus pen or
plastic-tipped pens on touch screen display.
Do not use pencil, pen or any other sharp
object.
