Tektronix WFM 601A Wheelchair User Manual


 
Reference
WFM 601A, WFM 601E & WFM 601M User Manual
3–43
Presets
The Preset menu makes it possible to recall front-panel settings from a list of 10
stored front-panel presets. You can store up to nine front-panel presets at these
locations. The remaining one is factory programmed to help calibrate the
waveform monitor.
Press the PRESET MENU button to access the list of the 10 presets. The list
appears over a bezel knob below the CRT. Rotating this knob moves the highlight
box up or down the list. Once the desired preset is selected, you can take one of
four actions:
RECALL. Sets the front panel to the stored settings previously stored into that
memory location.
STORE. Wipes out the currently stored settings, in the selected memory location,
and replaces them with the current front–panel settings.
RENAME. Allows you to change the name of the current preset selection using a
set of alpha-numeric characters and symbols.
RECOVER. Returns to the previously selected choice. For example, assume that
Preset 1 was the previous choice and Preset 8 has now been selected but not
recalled. Pressing RECOVER returns to Preset 1.
To restore the Preset menu, press the PRESET menu button again. To turn off the
Recall function, press CLEAR MENU or the PRESET menu button.
Use the Preset Rename submenu to rename one of the nine Presets.
1. Rotate the Location bezel knob to select a character to change in the current
name.
2. Rotate the Letter bezel knob to scroll through the list of available characters.
The Location character changes as you scroll through the character list. The
blank character follows the letter Z.
3. When you are done, press the ACCEPT button to lock the selection.
4. Press the RETURN bezel button to return to the PRESET menu.
Preset Menu
Rename Submenu