Tektronix WFM 601A Wheelchair User Manual


 
Eye Pattern Commands
WFM 601A, WFM 601E & WFM 601M User Manual
C–33
Eye Pattern Commands
The commands in this section allow you to select either the Eye or EQEye
displays and to toggle between the Overlay and 10 Eye modes. Use the
command DISPlay:SINGLE:EYe to enable the Eye display.
EYe:DISPlay < FLAT | EQEYE> (WFM 601M Only)
Selects either the Flat (or raw) digital data stream or an Equalized data stream for
the Eye display. The Flat mode corresponds to the EYE bezel button selection in
the Eye display mode. The EQEYE mode compensates for cable loss in a long
cable by applying receiver equalization to the signal.
EYe:DISPlay <FLAT | EQEYE>
EYe[:DISPlay]?
<FLAT | EQEYE>
ey:disp eqeye
eye:disp?
:EYE:DISPLAY EQEYE
EYe:MODE <OVERLAY | EYE10> (WFM 601E and WFM 601M Only)
Selects the trigger mode for the Eye display. OVERLAY displays three eyes and
EYE10 displays 10 eyes.
EYe:MODE <OVERLAY | EYE10>
EYe[:MODE]?
<OVERLAY | EYE10>
eye:mode eye10
eye:mode?
:EYE:MODE EYE10
Syntax
Arguments
Examples
Returns
Syntax
Arguments
Examples
Returns