Filter
Top Products
45
930336 Rev. E
• To exit drive or actuator mode select, simply push the on/off/mode toggle
up one or more times until the indicator no longer flashes, or push the
joystick forward or reverse to begin driving.
5. Joystick (E):
The joystick controls the direction and speed of your chair.Turn the chair on
and move the joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disengages the
motor locks, allowing the chair to move.
• The chair will move faster the more you move the joystick away
from neutral.
Note: If your speed becomes hard to manage, release the Joystick and the chair will
come to a complete stop.
• When you release the joystick it will return to neutral; the chair will slow
to a stop and the motor locks will reengage.
• We recommend that you switch the chair off if you stop for any length of
time.This will conserve battery power.
Note: Once the chair stops, switching the chair off will not affect the motor locks.
6. Joystick Boot(F):
Make sure the boot is not torn or cracked (this could allow debris, water or moisture
to enter). If the boot is torn or cracked, replace it as soon as you can.
7. Remote Switch Jacks (optional) (I):
Two 1/8” switch jacks are optional to provide remote switch control of the on/off
power function and the mode select function. Any of the single switches offered by
Sunrise Medical can be used to connect to either or both of these jacks (except the
single zero touch switch).
1. Never use the ON/OFF switch to stop your chair except in an emergency.This will
result in an abrupt stop, and may cause you to fall.
2. To slow or stop your chair, return the joystick to neutral.
X. OPERATING GUIDE
44
930336 Rev. E
E. JOYSTICK ASSEMBLY
The joystick connects to a controller, which
controls the chair’s performance.The joystick
assembly consists of the following parts:
1. Speed Control Knob (A):
Use the speed control knob to adjust the
maximum speed of your chair.Turn it
counter-clockwise to reduce speed; turn
it clockwise to increase speed.
2. Battery Charge Indicator (B):
• Green lights indicate that batteries are
fully charged.
• Yellow lights indicate that batteries need
recharging.
• When the lights stay in the red band,
the batteries must be recharged.
3. On/Off Mode switch (D)
The on/off mode switch is located on the
rear face of the joystick housing. It is a
toggle switch.Turning the chair on or off, is
accomplished by pressing the switch
downward.The switch will automatically
return to the center point.Alternate
locations exist for this switch. Please see
your supplier in the event that you wish to
relocate or re-orient this switch.
4. Mode Switch (D)
The on/off mode switch allows you to select
from 5 (five) different programmable drive
profiles or actuator mode sets.
• Push up the on/off mode select toggle
switch to index among the five drive
and actuator modes.The selected
mode indicator will flash.
• Push joystick either left or right to
select one of the five drive profiles.To
select the actuator modes, push the
mode select switch twice.
• The drive profiles are indicated by the
mode indicators (G) and the actuators
are indicated by the four actuator
lights (H).
X. OPERATING GUIDE
A
D
E
F
G
H
B
Remote Joystick
I