Filter
Top Products
35
930336 Rev. E
IX. SET-UP, ADJUSTMENT & USE
2. Back Angle Adjustment
A 12º angle-adjustment is standard on all
Quickie P200 wheelchairs. It can be
adjusted in 4° increments by:
a. Remove the front securing bolt (B)
using a 3/16" allen wrench on the side
of the backrest hinge plate.
b. Loosen the lower rear bolt (C ) using
a 3/16" allen wrench.
c. Set at desired angle
d. Replace the front bolt.There are four
holes (in 4º increments) to choose from
e. Tighten securely.
f. Retighten lower bolt.
Important Note: The adjustment on both
sides of the wheelchair must be equal.
L. 10" DRIVE WHEEL
1. Center of Gravity Adjustment
a) Remove the seat frame and the batteries.
b) Remove 10” drive wheels by removing
four center bolts (A) using a 3/16"
allen wrench.
c) Remove the two bolts (B) using a 1/2"
wrench from each quick-connect socket.
d) Move the socket forward or back-
wards to the desired position.
e) Reinstall the two bolts in the quick-con-
nect socket. Use a torque setting of 240
in.-lbs. (27
N
.
m) to tighten bolts.
f) Securely tighten drive wheel bolts. Use
a torque setting of 300-360 in.-lbs.
(34-40
N
.
m) to tighten bolts.
B
A
B
C
34
930336 Rev. E
IX. SET UP, ADJUSTMENT & USE
3. Replacing Armrest
a) Slide armrest back into receiver.
b) Return release lever to locked
position against armpost
4. Height-Adjustment
a) Push front of release lever to first stop.
Continue rotation to second stop by
pulliing on rear of release lever.
b) Slide armrest pad up or down to
desired height.
c) Return lever to locked position
against armpost.
d) Push arm pad until upper armpost
locks firmly into place.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer
armpost in the receiver:
a) Loosen the four bolts (9) on the sides
of the receiver using a 7/16" wrench.
b) With the armrest in the receiver,
squeeze the receiver to achieve the
desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws (7) are installed in the
outer armpost.
b) Turn the set screws in or out using a
1/8" allen wrench until the desired fit
is achieved.
K. SEAT DEPTH
1. Seat Depth Adjustment
The backrest can be moved forward or
rearward by:
a) Remove the backrest pivot plate
securing bolts (A) using a 3/16"
allen wrench.
b) Reposition the backrest pivot plate in
line with the predrilled holes on the
side of the frame.
c) Replace the bolts and tighten securely.
Note: The armrest may also be repositioned
if desired.
A
9
2
6
7
1
4
3
5
8
Height-Adjustable Armrest Key
1. Inner Arm Post
2. Receiver
3. Release Lever, Locked Position
4.Armrest Pad
5.Transfer Bar
6. Side Panel
7.Tension Adjustment Set Screw
8. Outer Arm Post
9. Receiver Adjustment Bolts