Filter
Top Products
33
930336 Rev. E
IX. SET-UP, ADJUSTMENT & USE
H. REMOTE JOYSTICK
SWING-AWAY RETRACTABLE
MOUNT (OPTIONAL)
The remote joystick is mounted with a
mechanism which allows the control to be
locked in a forward or retracted position.
1. Adjustment
a) To retract joystick, depress lever (B)
located on side of armrest.
b) Push joystick away from front of armrest
until it locks into retracted position.
c) To return to forward position, depress
lever and push joystick forward until it
locks into place.
I. DUAL-POST HEIGHT-
ADJUSTABLE ARMRESTS
1. Installation or Removal
a) The assembly is held securely in place
when the lever is facing forward.
b) Pull back on securing lever.
c) Insert or remove armrest.
d) Return securing lever to locked position.
2. Height-Adjustment
a) Release the upper securing lever.
b) Set at desired height
c) Return securing lever to locked position.
d) Move armrest up or down to allow
armrest to snap into place
J. HEIGHT-ADJUSTABLE
ARMRESTS (OPTIONAL)
1. Installation
a) Slide the outer armpost into the receiver
mounted to the wheelchair frame.
b) The armrest will automatically lock
into place.
2. Removing Armrest
a) Rotate release lever to first stop and
remove the armrest
B
32
930336 Rev. E
IX. SET UP, ADJUSTMENT & USE
E ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest
(ELR) see instructions for Swing-away
Footrest installation page 29.
2. Adjustment
a) To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b) To lower legrest, while seated in chair,
lift legrest slightly while lifting release
lever (A) up and lower legrest to
desired position. Legrest will automat-
ically lock in place.
F. REMOTE JOYSTICK
INSTALLATION
1. To Connect
a) Line up small cylindrical connector with
its receptacle on the rear of the joystick.
b) Push in firmly.
2. To disconnect
Pull back on the retaining ring (A) of the
cylindrical connector until it disconnects
from the joystick box.
G. TO ADJUST THE HEIGHT OF
THE REMOTE JOYSTICK
a) Remove the two pan-head screws (A),
securing the angle bracket mount (B).
b) Remove the Joystick from the mount
by unfastening the two screws (C) on
the underside of the mount.
c) Position angle bracket mount such that
you achieve the desired joystick height.
Four positions are available by
relocating the mount either on the top
or bottom of the mounting bar (D)
and/or by rotation of the angle
bracket mount.
A
A
A
C
B
D