Filter
Top Products
19
930336 Rev. E
VI. GENERAL WARNINGS
Q. OBSTACLES
Obstacles you may have to overcome in daily use include door thresholds, lifts,
ramps and hazards such as potholes and broken pavement.These can damage
your chair and may cause a fall, tip-over or loss of control.
1. Be aware that thresholds are very dangerous. (Even a small change in height
may stop a caster wheel and cause your chair to tip). You may need to:
• Remove or cover threshold strips between rooms.
• Install a ramp at entry or exit doors.
2. Keep your eyes moving when you ride; scan the area well ahead of your chair.
3. Make sure the floor areas where you use this chair are level and free of obstacles.
4. To help correct your center of balance:
• Lean your upper body forward slightly as you go up over an obstacle.
• Press your upper body backward as you go down from a higher to
a lower level.
R. DRIVING IN REVERSE
Use extra care when you drive your chair in reverse.You may lose control or
fall if one of the rear wheels hits an object.
1. Operate your chair slowly and at an even speed.
2. Stop often and check to make sure your path is clear of obstacles.
S. RAMPS, SLOPES & SIDE HILLS
The center of balance of your chair changes when you are on a slope.
Note: “Slope” includes a ramp or side hill.Your chair is less stable when it is at an
angle. Never use this chair on a slope unless your are sure it is safe.When in doubt,
have someone help you.
Beware Of:
1. Steep slopes. Do Not use this chair on a slope steeper than 10%. (A 10% slope
means: One foot in elevation for every ten feet of slope length).
2. Wet or slippery surfaces (such as when ice, snow, water or oil film is present).A loss
of traction may cause a fall or tip-over.
3. A change in grade on a slope (or a lip, bump or depression).These may
cause a fall or tip-over.
4. A drop-off at the bottom of a slope. (A drop-off of as small as 3/4 inch (12 mm) can
stop a front caster and cause the chair to tip forward).
18
930336 Rev. E
VI. GENERAL WARNINGS
O. REACHING OR LEANING
Reaching or leaning affects the center of balance of your chair. If done improperly,
a fall or tip-over is likely.When in doubt, ask for help or use a device to extend
your reach.
TO REDUCE THE RISK OF INJURY AND/OR DAMAGE TO THE
CHAIR:
1. Never reach or lean if you must shift your weight sideways or rise up off the seat.
2. Never reach or lean if you must move forward in your seat to do so.Always
keep your buttocks in contact with the backrest.
3. Never reach with both hands (you may not be able to catch yourself to prevent a
fall if you lose your balance).
4. Never try to pick up an object from the floor by reaching down between
your knees.
5. Never put pressure on the footrests while reaching.This may cause the chair
to tip if you lean too far.
6. Never reach or lean over the top of the seat back.This may damage the back-
rest and cause you to fall.
IF YOU MUST REACH OR LEAN; DO SO AT YOUR OWN RISK.
Remember to:
1. Move your chair as close as you can to the object you wish to reach.
2. Rotate the front casters until they are as far forward as possible.This makes the
chair more stable.
Note: To do this: Move your chair past the object you want to reach, then back
up alongside it. Backing up will rotate the casters forward.
3. Turn off all power to your chair. If you fail to do so, you may touch the joystick
and cause your chair to move when you do not expect it.
4. Firmly grasp a rear wheel or an armrest with one hand.This will help to
prevent a fall if the chair tips.
P. DRESSING OR CHANGING CLOTHES
Be aware that your weight will shift if you dress or change clothes while seated
in this chair.To make the chair more stable, rotate the front casters until they
are forward.