Filter
Top Products
39
930336 Rev. E
IX. SET-UP, ADJUSTMENT & USE
D. 24" REAR WHEELS
1. Installation
a) Depress the quick-release button (A)
on the axle.
b) Slide it into the axle sleeve until it locks.
E. ANTI-TIP TUBES
Sunrise Designs recommends anti-tip
tubes for all wheelchairs.
Note: Use a torque setting of 100 in.-lbs.
when setting-up anti-tip receivers.
1. Inserting Anti-Tip Tubes Into Receiver
a) Press the rear anti-tip release lever
on the anti-tip tube so that both
release pins are drawn inside.
b) Insert into the anti-tip tube receiver.
c) Turn the anti-tip tube down until
release pin is through the receiver.
d) Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be
raised or lowered to achieve proper
clearance of 1 1/2" to 2".
a) Press the anti-tip wheel release
button so that both release pins
are drawn inside.
b) Raise or lower to one of the four
predrilled holes.
c) Release button.
d) Adjust the second anti-tip tube wheel
the same way. Both wheels should be
exactly the same height.
3. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed
by attendant, overcoming obstacles or
climbing curbs.
a) Press the rear anti-tip tube release lever.
b) Hold lever in and turn anti-tip tube up.
c) Release lever.
d) Repeat with second anti-tip tube.
e) Remember to return anti-tip tubes
to down position after completing
maneuver.
A
38
930336 Rev. E
IX. SET-UP, ADJUSTMENT & USE
A
C
B
MANUAL WHEELCHAIR
CONVERSION KIT
A. JOYSTICK
1. Removal
a) Disconnect the joystick by pulling
back on the retaining collar (A).
b) Remove joystick power cable from
armrest.
c) Remove joystick assembly.
B. POWER DRIVE UNIT
1. Detachment
a) Turn both quick-connect knobs (A)
counterclockwise until completely
disengaged.
b) Lift seat frame off of power unit.
c) Set power unit aside.
C. WHEEL LOCKS
Wheel locks are installed by Sunrise when
requested on the Quickie P200.
1. Installation
a) Insert wheel lock cylinder into
receiver (B).
b) Secure by inserting quick-release
pin (C) into pin hole on wheel
lock assembly.
2. Adjustment
The wheel lock mounts on a split clamp
system. Use a torque setting of 100in./lbs
(11.3
N
.
m) when adjusting wheel locks.
a) Loosen the screws on the side of each
clamp using a 3/16" allen wrench.
Do not attempt to remove one screw
at a time.
b) Slide assembly toward rear wheel until
clamp embeds into tire to prevent wheel
movement, when in locked position.
c) Adjust angle position.Tighten screws.
A