Filter
Top Products
17
Installation
For the HDLA1507
Place the camera inside and slide it forward until it
locks in place.
6
Close the rear panel.
Check that the rear panel is locked firmly.
To remove the camera
While the figures of the adaptors in the following steps
show the states where the studio lens and the large
viewfinder have been already removed, the camera can
also be removed with the lens and viewfinder attached to
the adaptor.
For the HDLA1505, start from step 2.
1
Pull the viewfinder table lock lever 1 toward the rear
panel, then pull the release knob 2 and slide the
viewfinder table in the direction of the arrow 3.
2
Push the rear panel lock release lever on the left panel
down to open the rear panel.
3
Remove the camera.
For the HDLA1500/1505
While holding the camera lock lever on the front panel
upward, and pull the camera rearward until it stops
then remove it.
[1500][1505]
[1507]
This camera release lever on the bottom of the adaptor
is used when removing the camera (page 18).
(The figure shows HDLA1500.)
Caution
2
3
1
[1500][1507]
(The figure shows HDLA1500.)