Filter
Top Products
13
When the battery power is being reduced, the Wireless External Alarm will emit 3
beeps when the remote arm or disarm the unit. It is time to replace the batteries or
recharge the battery pack (rechargeable battery only) as soon as the low battery
signal appears. Ensure all the batteries are replaced altogether at the same time.
The Wireless External Alarm is powered by 3 AA-size Alkaline batteries as the
backup purpose. Follow the instructions below to replace the batteries;
1. Remove the cover of the Wireless External Alarm as shown.
2. Remove the old battery. Insert 3 new AA-size Alkaline batteries to the
battery compartment. Beware of the battery polarity.
3. Install the cover.
cAuTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
The Wireless External Alarm is built-in with the Tamper Protection for system
security. When the cover is removed or move the unit to other location after
mounted on the wall, the Wireless External Alarm will siren when the Tamper Switch
is activated.
Please disarm the unit before you replace the battery or before you conduct any
kind of service maintenance (i.e. checking or cleaning the unit)
The External Wireless Alarm SA-001S is equipped with a solar panel, this solar pan-
el is installed on top of the cover to charge rechargeable batteries during the day.
During darkness, a insignicant amount of energy is released from the rechargeable
battery to operate the external wireless alarm.
The Wireless External Alarm should be installed to the outside of your house or
building in a position to gather as much sunlight as possible. Avoid any shadows
cast by walls, trees and roof overhangs to the Wireless External Alarm. Ideally to
install the Wireless External Alarm facing due south optimize for solar exposure.
However, install the unit facing east or west position will sufce.
BATTEry
TAmPEr PrOTEcTION
sOLAr POWEr INsTALLATION (ONLy APPLIcABLE TO sA-001s)