Filter
Top Products
US Jazzy 1113/Rev I/Feb03 www.pridemobility.com 47
X. CARE AND MAINTENANCE
ROUTINE MAINTENANCE
Your Jazzy is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks. You
can perform some of these checks, but others require assistance from an authorized Pride provider. Preventive
maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can help
ensure that your Jazzy gives you years of trouble-free operation. If you have any doubt as to your Jazzys care or
operation, contact your Pride provider.
CAUTION
!
Your Jazzy 1113, like most electrical equipment, is susceptible to damage from the
elements. Avoid damp areas of any kind. Direct exposure to water or dampness could cause the
power chair to malfunction electronically and mechanically. Water can cause electrical
components to corrode and the chairs frame to rust.
Should your Jazzy 1113 come in contact with water:
1. Dry your Jazzy 1113 as much as possible with a dry towel.
2. Allow your Jazzy 1113 to sit in a warm, dry place for 24 hours to allow unseen
water to evaporate.
3. Check the joystick operation and the brakes before using your Jazzy again.
4. If any inconsistencies are found, take your Jazzy 1113 to an authorized service center.
TEMPERATURE
Some of the parts of your Jazzy 1113 are susceptible to extreme changes in temperature. Always keep your Jazzy
1113 between the temperatures of 32° F and 122° F.
n In extremely cold temperatures, the batteries may freeze. The specific temperature at which they freeze
depends on a number of factors such as battery charge, usage, and composition of the batteries (e.g., Sealed
Lead Acid or Gel Cell).
n Temperatures above 122° F may cause the Jazzy 1113 to operate at a reduced speed. This is a safety feature
built into the controller that helps prevent damage to the motor and other electrical components. See VIII.
Operation in this manual.
GENERAL GUIDELINES
n Avoid knocking or bumping your controller, especially the joystick.
n Avoid prolonged exposure of your Jazzy to extreme conditions such as heat, cold, or moisture.
n Keep the controller clean.
n Check all connections on the electronics connector housing to ensure that they are all tight and secured properly.
Also, check the charger harness connector.
n When the battery indicator gauge is completely lit, the batteries are fully charged, and the controller and
electrical system are OK.
n If one red bar on the battery indicator gauge is blinking slowly, the batteries are low and need to be charged,
but the controller and electrical system are OK.
n If the battery indicator gauge is blinking rapidly, the controller has detected a fault in either its own circuits or
in the Jazzys circuits. See VIII. Operation in this manual.