US Jazzy 1113/Rev I/Feb03 www.pridemobility.com 41
VIII. OPERATION
capacity. If the battery has at least 85% of its rated capacity, all of the lights will be on. As the battery voltage drops, the number
of lights reduces from right to left. When the battery capacity drops to 10% or below, all of the lights will flash once every
second.
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller was
preprogrammed at the factory for five drive programs 1(slowest) to 5(fastest). The drive mode is indicated by a number in
the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your authorized Pride provider changes these settings,
please make note of these changes.
To change the drive mode program:
1. Press the drive mode select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven-segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if applicable),
when they occur.
Actuator Select Keys with Lights
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can
operate them through the remote keypad. Contact your authorized Pride provider for information on how to
operate these accessories.
Remote Status Light
This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred. See Out Of Neutral
At Power Up.
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance to
conserve battery power.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front
of the Europa. See figure 32. If you use and off-board charger, the charger current should not exceed 8 amps.
Contact your authorized Pride provider for more information.