Pride Mobility Jazzy 1113 Mobility Aid User Manual


 
US Jazzy 1113/Rev I/Feb03 www.pridemobility.com 39
VIII. OPERATION
DX CONTROLLER
The Dynamic DX electronic control system is a modular system. The electronics necessary to operate the power chair are
contained in several modules located on different parts of your power chair.
The Dynamic DX system consists of the following components:
n master remote (Europa)
n communications cable(s)
n power module
n motor wiring harnesses
n battery wiring harnesses
n actuator lighting module (for optional systems)
The master remote is located typically on the end of an
armrest. The other components are located inside the
power base.
Europa Master Remote
The Europa master remote consists of the following
(see figure 31):
1. joystick
2. keypad
3. controller communications connector
4. off-board charger/programming socket
Joystick
The joystick controls the direction and speed of the power chair. When you move the joystick from the neutral (center) position,
the electromagnetic brake will release and allow the power chair to move. The further you push the joystick from its neutral
position, the faster your power chair will move. When you release the joystick and allow it to return to the neutral position, you
engage the electromagnetic brake. This helps the power chair decelerate and come to a complete stop. You can also use the
joystick control power actuators.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the
joystick. Unless the joystick is damaged, this action should stop your power chair.
Out Of Neutral At Power Up
Your power chair joystick is equipped with Out Of Neutral At Power Up (OONAPU). If you power up the system and the
joystick is not in the neutral position, the system status light flashes rapidly for either as long as the joystick is out of the neutral
position or five seconds. If this has happened and the all the segments on the battery condition meter are flashing, you may have
set a fault code. See Fault Codes.
Keypad
The keypad is located directly in front of the joystick. It contains keys that you will use to control your power chair.
See figure 32.
1/0
1/0
1
2
3
4
Figure 31. Europa Master Remote