Filter
Top Products
These messages will continue
to display until you turn the
meter off or for two minutes,
after which the meter auto-
matically turns off. You may
now proceed with a blood
glucose test.
If the reading is not within the
acceptable range, the meter
display will read
A 38
A not ok
redo A
(example)
Go back to Step 1 and repeat
the check strip test. If this
message appears again, clean
your meter. For information,
see page 42. For further
assistance, call LifeScan
Customer Services.
The next time you turn on
your meter,
code 7
redo A
(example)
will appear, indicating that
your check strip test result
was out of range at the
last reading.
This message will appear each
time the meter is turned on
until you perform a check
strip test that falls in the
acceptable range.
CAUTION: If your check
strip test result falls outside
the acceptable range, the
meter is not working
properly. Do not use the
meter to test your blood
until you get a check strip
test result that is within
the acceptable range. For
assistance, call LifeScan
Customer Services.
13
LSI-99-221_9/2/99 11/11/99 11:01 AM Page 13