Filter
Top Products
Tracer® EXI 30 Part No. 1110547
EXI WITH FIXED FRAME (FIGURE 4)
Removing Lower Mounting Hardware (DETAIL "A").
1. Remove the existing back and seat upholstery from the wheelchair. Refer to
RE-
PLACING THE BACK UPHOLSTERY and REPLACING THE SEAT UPHOLSTERY
in this section of the manual.
NOTE: If adjusting the seat width of the wheelchair, back and seat upholstery as well as the
crossbraces MUST be replaced.
2. Remove the four (4) screws and locknuts that secure the insert tube to the lower
wheelchair frame.
3. Remove the inserts from the rear of the wheelchair.
4. Remove the hex screw and locknut that secure the two (2) existing crossbraces
together.
Removing Upper Mounting Hardware (DETAIL "B").
1. While pushing down on the rear seat guide, pull up the front seat guide until the
front seat guide releases from the wheelchair frame.
2. Pull the crossbrace away from the rear seat guide.
3. Repeat STEPS 1-2 for opposite crossbrace.
4. Reverse STEPS 1-3 to assemble the upper mounting hardware.
5. Reverse STEPS 1-4 in REMOVING LOWER MOUNTING HARDWARE in this
section of the manual to reassemble the wheelchair.
Rear Seat Guide
Front Seat Guide
FIGURE 4 - ADJUSTING SEAT WIDTH - EXI WITH FIXED FRAME
Crossbrace
Hex Screw
Locknut
Wheelchair
Frame
Screw
Crossbrace
Insert Tube
DETAIL "A" - REMOVING LOWER
MOUNTING HARDWARE
DETAIL "B" -
REMOVING UPPER
MOUNTING
HARDWARE
SECTION 5 SEAT AND BACK
SEAT AND BACK