Filter
Top Products
Part No. 1110547 21 Tracer® EXI
FRONT RIGGINGS
FRONT RIGGINGS
SECTION 3
Section 3 - Front Riggings includes the following:
Installing/Removing the Front Riggings
Footplate Height Adjustment
Adjusting the Elevating Legrest Assembly
Heel Loop Replacement
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
INSTALLING/REMOVING THE FRONT RIGGINGS
(FIGURE 1)
NOTE: This procedure applies to the swingaway footrests and the elevating legrest.
INSTALLING
1. Turn the front rigging assembly to the
side (open front rigging is perpendicu-
lar to wheelchair).
2. Install the hinge plates on the front
rigging assembly onto the hinge pins on
the wheelchair frame.
3. Push the front rigging assembly to-
wards the inside of the wheelchair
until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the other
footplate assembly.
5. To release the front rigging, push the front rigging release lever inward, rotate front
rigging outward.
REMOVING
1. Push the front rigging release lever inward
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off of the hinge pins.
FIGURE 1 - INSTALLING/REMOVING
THE SWINGAWAY front rigging
Hinge Pins
Front Rigging
Assembly
Hinge
Plates
Front Rigging Release
Lever
Footplate
NOTE: Swingaway footrests shown.