Filter
Top Products
Part No. 1110547 25 Tracer® EXI
SECTION 3FRONT RIGGINGS
FRONT RIGGINGS
FIGURE 6 - HEEL LOOP REPLACEMENT
Spacer
Locknut
Cam Lock Lever
Heel Loop
Slide Tube
Mounting Screw
Footplate Assembly
Footplate
OUTSIDE OF
SWINGAWAY
FRONT
RIGGING
INSIDE OF
SWINGAWAY
FRONT
RIGGING
NOTE: Swingaway
footrests shown.
Footplate Assembly
Front Rigging
Support
Cam Lock Lever
Riv Nut
Button Head
Screw
Footplate
Assembly
Front Rigging
Support
Adjustment
Hole
NOTE: Swingaway footrest shown.
Front Rigging
Support
Footplate
Assembly
Cam Lock Lever
Release
Button
Adjustment
Holes
DETAIL "A"
BOLT-IN-PLACE
FOOTPLATES
FOOTPLATES WITH
SPRING BUTTONS
7. Insert the lower footrest assembly into the upper footrest assembly to desired
height.
8. Perform one (1) of the following as shown in DETAIL "A" of FIGURE 6:
A. FOOTPLATES WITH SPRING BUTTONS: Ensure that the release buttons fully
protrude from holes on both sides of the upper footrest support.
B. BOLT-IN-PLACE FOOTPLATES:
From the outside of the swingaway front rigging, insert the riv nut through
both the front rigging support and the footplate assembly.
From the inside of the swingaway front rigging, insert the button head screw
through the appropreate adjustment hole and thread into the riv nut.
. Using a screwdriver to hold the riv nut in position, securely tighten the
button head screw. Torque to 32 in-lbs.
9. Rotate cam lock lever DOWN to LOCKED position.