Support User Manuals

Invacare Pronto M51 Base Mobility Aid User Manual

Open as PDF

of 72

SECTION 7—FOOTBOARD ASSEMBLY

Part No. 1148076 45 Pronto

®

M51

™

Base with SureStep

®

Installing

ƽ WARNING

Make sure the detent balls of the quick-release pin are fully released beyond the

outer edge of the tube before operating the wheelchair. Otherwise, injury and/or

damage may result.

Keep detent balls clean.

1. Positionthefootboardassemblyontothewheelchairframesothatthemountinghole

inthewheelchairframealignswiththedesiredmountingholeinthefootboard

assembly.

2. Installthequickreleasepinbydepressingthebuttonwhileslidingthepinin.Ensure

thatthedetentballsofthequickreleasepinarefullyreleasedbeyondtheouteredge

ofthetube(Detail“A” ofFIGURE 7.1).

FIGURE 7.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle

NOTE:Forthisprocedure,refertoFIGURE 7.2onpage 46.

1. Loosenthejamnutandsetscrewlocatedunderneathonthebacksideofthefootplate.

2. Adjustthesetscrewinorouttoobtainthedesiredfootboardassemblyangle.

3. Threadthejamnutandwasherinwarduntilitisflushwiththefootboardbracket.

4. Securelytightenthejamnutandwashertosecurethemountingscrewinplace.

DETAIL “A” - BOTTOM VIEW OF

FOOTBOARD

Quick Release Pin

Outer Edge

of Tube

Detent Balls

Quick

Release Pin

Detent

Ball

Footboard

Assembly

Mounting

Hole

Three Depth

Adjustment Holes

previous next