Support User Manuals

Invacare Pronto M51 Base Mobility Aid User Manual

Open as PDF

of 72

SECTION 6—SEAT

Part No. 1148076 43 Pronto

®

M51

™

Base with SureStep

®

Removing/Installing the Seat Assembly

NOTE:Forthisprocedure,refertoFIGURE 6.2.

NOTE:ThisprocedureisforwheelchairsWITHOUTtheFormulaPTOPlusseatingsystem

installedONLY.ForwheelchairswiththeFormulaPTOPlusseatingsystem,refertoTiltingthe

SeatAssembly(FormulaCGOnly)onpage 41.

Removing

1. Disconnectthejoystickcableatrearofseat.RefertoDisconnecting/Connectingthe

Joysticksonpage 44.

2. Pushdownonthelatchbarunderneathfrontofseat.

3. Rotateseatassemblybackward.

4. Slidetheseatassemblyforw ardtodisengageseatfrompivotbracketslocate dinth e rear.

Installing

1. PositiontheseatintherearpivotbracketsasshowninFIGURE 6.2.

2. Rotateseatassemblyforward.

3. Whenseatislowered,engageseatbracketsintoseatclevispins.

ƽ WARNING

When reinstalling the seat verify that the seat brackets are engaged with the seat

clevis pins by pulling up on the latch bar.

4. Pulluponlatchbartoverifythatbracketsareengagedwithseatclevispins.

FIGURE 6.2 Removing/Installing the Seat Assembly

Latch Bar is located

under the front of the

seat

Rear Pivot

Brackets

Seat Clevis

Pins

previous next