Filter
Top Products
SECTION 8—WHEELS
Xtra™ 54 Part No 1026793
Installing Quad-Release Axles
NOTE: For this procedure, refer to FIGURE 8.3.
1. Remove rear wheel and the existing
quick-release axle from the wheelchair.
2. Remove the existing quick-release axle
from the rear wheel hub.
3. Insert the new quad-release axle
through the rear wheel hub.
4. Slide the locking collar onto the quad-
release axle until it is snug against the
rear wheel and tighten securely with
the allen screw.
5. Reinstall rear wheel and the quad-
release axle onto the wheelchair.
FIGURE 8.3 Installing Quad-Release Axles
ƽ WARNING
Make sure the detent pin and locking pins of the quad-release axle are fully released
BEFORE operating wheelchair.
Keep locking pins clean.
6. Flip the handle of the quad-release axle down to release the detent pin ensuring that
the locking pins are fully released.
7. If detent pin does not fully release, proceed to Adjusting Quad-Release Handles on
page 55.
8. Repeat STEPS 1-7 for the opposite rear wheel.
Quad-Release Axle
Locking Pin
Axle Mounting Plate
Allen Screw
Locking Collar
Rear Wheel Hub