Filter
Top Products
SECTION 4—FRONT RIGGINGS
Xtra™ 30 Part No 1026793
Installing Elevating Legrests
NOTE: For this procedure, refer to FIGURE 4.3.
1. Insert the pivot tube into the legrest support and secure it with the bolt and nut.
2. Place legrest on the outside of the wheelchair and insert the mounting pin into the
mounting tube.
3. Rotate legrest toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footrest to correct height by loosening nut and
sliding the pivot tube up or down until desired height is obtained.
6. To release the legrest, push the legrest release handle toward the inside of the
wheelchair and swing the legrest to the outside of the wheelchair.
FIGURE 4.3 Installing Elevating Legrests
Raising/Lowering Elevating Legrests
NOTE: For this procedure, refer to
FIGURE 4.4.
Perform one (1) of the following:
• Raising - Pull back on the release
lever until the leg is at the desired
height.
• Lowering - Support leg with one (1)
hand and push release lever
downward with other hand.
FIGURE 4.4 Raising/Lowering Elevating
Legrests
Calfpad
Bolt and Nut
Footrest Assembly
Pivot Tube
Legrest Release Handle
Mounting Pin
Mounting Tube
Footplate
Release Lever