Filter
Top Products
SECTION 7—ARMS
Xtra™ 46 Part No 1026793
Removing T-Arms
1. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.
NOTE: If the T-arm does not slide up and down in the T-arm socket as desired, adjust the T-arm
socket. Refer to Adjusting the T-Arms on page 46.
2. Repeat STEP 2 for opposite side of the wheelchair.
FIGURE 7.5 Installing/Removing T-Arms
Adjusting the T-Arms
Adjusting T-Arm Height
NOTE: For this procedure, refer to FIGURE 7.6.
1. Unlock the T-arm by flipping the T-arm release lever towards the inside of the
wheelchair.
NOTE: If necessary, pull out on the T-arm release lever and rotate 180° so it can be flipped towards
the outside of the wheelchair.
2. Slide the T-arm to one (1) of:
• Low Height T-Arms - Nine (9) positions.
• High Height T-Arms - Seven (7) positions.
NOTE: If the inside T-arm post does not slide up and down in the outside T-arm post as desired,
perform one (1) of the following:
Locking Lever
(Towards the front
of the wheelchair)
Wheelchair
Frame
T-Arm
T-Arm
Socket
Slot