Filter
Top Products
Airport Systems
PLC Health Monitoring & Reporting Sys vi Manual EPM40002083-001 Rev -
QUALIFIED PERSONNEL
The term “qualified personnel” is defined here as individuals who thoroughly understand
the equipment and its safe operation, maintenance, and repair. Qualified personnel are
physically capable of performing the required tasks, familiar with all relevant safety rules
and regulations and have been trained to safely install, operate, maintain, and repair the
equipment. It is the responsibility of the company operating this equipment to see that
its personnel meet these requirements.
INTERLOCKS
This equipment contains interlocks for your protection. To ensure safety, always
remove power from the equipment prior to opening access panels or doors if possible.
Do not depend on the interlocks or door switches when working with the equipment. Do
not short-circuit or tamper with any access gate, door or other safety interlock switch.
Discharge capacitors with an approved insulated grounding rod prior to touching any
part. When it is absolutely mandatory that an interlock be bypassed for the purpose of
tracing or correcting a malfunction, authorized maintenance personnel may perform the
bypass for the specific test to be made. Immediately after completing the test, restore
the interlock to working condition.
WARNING!
INTENDED USE
HONEYWELL IS NOT RESPONSIBLE FOR INJURIES OR DAMAGES
RESULTING FROM NONSTANDARD, UNINTENDED APPLICATIONS OF
ITS EQUIPMENT. THIS EQUIPMENT IS DESIGNED AND INTENDED
ONLY FOR THE PURPOSE DESCRIBED IN THIS MANUAL. USES NOT
DESCRIBED IN THIS MANUAL ARE CONSIDERED UNINTENDED USES
AND MAY RESULT IN SERIOUS PERSONAL INJURY, DEATH OR
PROPERTY DAMAGE. UNINTENDED USES MAY RESULT FROM
TAKING ANY OF THE ACTIONS LISTED BELOW.
1. Making changes to the equipment that have not been recommended
or described in this manual, or using parts that are not genuine
Honeywell replacement parts.
2. Failing to make sure that auxiliary equipment complies with
approval agency requirements, local codes, and all applicable
safety standards.
3. Using materials or auxiliary equipment that are inappropriate or
incompatible with your Honeywell equipment.
4. Allowing unqualified personnel to perform any task.