Filter
Top Products
Airport Systems
PLC Health Monitoring & Reporting Sys 3-1 Manual EPM40002083-001 Rev -
SECTION 3. INSTALLATION & POWER UP
WARNING!
Modifications to the Power Supply are required for certain applications.
Remove input power at circuit breakers and discharge capacitors with
an approved grounding rod before attempting any necessary
modifications.
3.1 Unpacking
Carefully unpack each item and remove any internal packing material from the
PLCHMR. Carefully check the supplied materials with the PLCHMR bill of materials.
There are many small items that should be supplied inside clear plastic bags, verify
each of these bags contain the proper amount of parts per the bill of materials. Report
any shortages of materials immediately to the Honeywell Technical Support.
Examine each item for obvious physical damage. Report any claims to the carrier
immediately. Pertinent information such as installation drawings, schematics,
interconnection drawings, and operation manuals are included in the carton. The
upgraded 8051 micro-controllers (MCU) replacements for the master control and each
flash head are in a separate package(s) inside the carton. Do not remove 8051 MCUs
from their respective packaging until you are ready to install them.
3.2 User Supplied Tools
PC computer with RS232 serial port,
Serial port parameters: 115200 baud, 8 data bits, no parity, 1 stop bit.
Terminal Emulator – MS Windows Hyper Terminal, Tera Term
Screwdriver ¼:” slot-type
Screwdriver 1/16” slot-type
Small Phillips screwdriver
DB9 to DB9 Female/Female RS2232 Null Modem Serial Interface Cable (Radio
Shack Model 03044 Catalog # 55010600 or equivalent)
3.2.1 Master Controls Switch Setting For Installation
Set Master Controller switches (Shown in Figure 2.2-2) as follows:
POWER SWITCH --------------------------------------------------------------------------- OFF
LOCAL / REMOTE Switch ------------------------------------------------------------ LOCAL
MODE Switch -------------------------------------------------------------------------------- DAY
The Master Controller has the following control switches (Figure 2.2-2):