Filter
Top Products
Flow Meter FC01-LQ Flow Meter FC01-LQ
Parameter selection 43 Parameter selection 43
6.5 Quitting the parameter selection menu
Before the parameter selection menu can be quitted, the controller will conduct a plausibility
check of the data entered.
“PARAMETERS OK!” is indicated when the data are found to be correct. The menu may then be
quitted by pressing MODE.
Errors found during the plausibility check are indicated in the following sequence of priority.
Priority of entry errors in the PARAMETER SELECTION menu:
• ERROR LS1 OUT OF RANGE
switch-on and/or switch-off value for limit switch 1 outside measuring range
• ERROR LS2 OUT OF RANGE
switch-on and/or switch-off value for limit switch 2 outside measuring range
• ERROR LS1 ON = OFF
switch-on value for limit switch 1 equals switch-off value for limit switch 1
• ERROR LS2 ON = OFF
switch-on value for limit switch 2 equals switch-off value for limit switch 2
The menu can only be quitted after correction of the error(s). To do this, return to the beginning
of the parameter selection menu by pressing UP or DOWN and select the menu option
with the incorrect entry for correction.
An overview of the parameter selection menu is shown on the following page.
▲
▼
M
6.5 Quitting the parameter selection menu
Before the parameter selection menu can be quitted, the controller will conduct a plausibility
check of the data entered.
“PARAMETERS OK!” is indicated when the data are found to be correct. The menu may then be
quitted by pressing MODE.
Errors found during the plausibility check are indicated in the following sequence of priority.
Priority of entry errors in the PARAMETER SELECTION menu:
• ERROR LS1 OUT OF RANGE
switch-on and/or switch-off value for limit switch 1 outside measuring range
• ERROR LS2 OUT OF RANGE
switch-on and/or switch-off value for limit switch 2 outside measuring range
• ERROR LS1 ON = OFF
switch-on value for limit switch 1 equals switch-off value for limit switch 1
• ERROR LS2 ON = OFF
switch-on value for limit switch 2 equals switch-off value for limit switch 2
The menu can only be quitted after correction of the error(s). To do this, return to the beginning
of the parameter selection menu by pressing UP or DOWN and select the menu option
with the incorrect entry for correction.
An overview of the parameter selection menu is shown on the following page.
▼
▲
M