Filter
Top Products
Deploying Application Connectivity Monitor
12 EMC Smarts Application Connectivity Monitor Configuration Guide
DomainType
{
ConfFile = "dxa-perf.conf";
MinimumCertainty = 0.24;
SmoothingInterval = 65;
## HookScript = "ics/dxa-sample-hook.asl";
Name = "INCHARGE-PM";
}
# DomainType definition for INCHARGE-OI.
DomainType
{
ConfFile = "dxa-oi.conf";
MinimumCertainty = 0.24;
SmoothingInterval = 65;
## HookScript = "ics/dxa-sample-nl-hook.asl";
Name = "INCHARGE-OI";
}
# DomainType definition for INCHARGE-ACM.
DomainType
{
ConfFile = "dxa-sam-from-acm.conf";
MinimumCertainty = 0.24;
SmoothingInterval = 65;
## HookScript = "ics/dxa-sample-hook.asl";
Name = "IC-ACM";
}
}
Reconfiguring the Global Manager
If you change the ics.conf file after the Global Manager is running, you need
to invoke a command so that the Global Manager will reload its
configuration file. This procedure is also referred to as reconfiguring the
Global Manager. Reconfiguring the Global Manager requires administrative
privileges, as defined by the Global Manager’s serverConnect.conf file.
To reconfigure the Global Manager, invoke the following command from the
BASEDIR/smarts/bin directory:
# sm_adapter -s <global_manager> ics/ICS_RemoteConfig.asl
where <global_manager> is the name of your Global Manager.
Depending on your security configuration, you may be prompted for your
EMC Smarts user name and password.
For additional information about configuring a Global Manager’s
configuration file or the ICS_RemoteConfig command, see the EMC
Smarts Service Assurance Manager Configuration Guide.