Filter
Top Products
EMC Smarts Application Connectivity Monitor Configuration Guide 7
License Reminder
• EMC Smarts Service Assurance Management Suite Installation Guide
• EMC Smarts IP Management Suite Installation Guide
If Service Assurance Management Suite 6.2 is installed, you will need to
install SmartPack 2. Apply SmartPack 2 to Service Assurance before
configuring communications between Service Assurance and Application
Connectivity Monitor.
See the EMC Smarts SmartPack Read Me First document that came with your
software for additional information.
License Reminder
For Application Connectivity Monitor, ensure that your license is in the
proper location:
• Evaluation license—Save trial.dat to the BASEDIR/smarts/local/conf
directory. Edit the SM_LICENSE variable in the runcmd_env.sh file so
that the variable specifies the full path name to the trial.dat file.
• Permanent license—Save smarts.lic to the BASEDIR directory. By
default, BASEDIR is /opt/InCharge6/ACM for UNIX and
C:\InCharge6\ACM for Windows.
See the EMC Smarts Application Connectivity Monitor Installation Guide
and EMC Smarts System Administration Guide for complete information
about licenses.
Integrating Application Connectivity Monitor
This section describes how to integrate Application Connectivity Monitor.
Instructions are organized by component. Figure 1 illustrates the architecture
and integration of Application Connectivity Monitor.
During the integration process, for some of the components, you need to
modify configuration files. Use the sm_edit utility to edit configuration files.
For example, to edit the ics.conf file for the Global Manager, enter the
following at the command line:
# BASEDIR/smarts/bin/sm_edit conf/ics/ics.conf