Filter
Top Products
26
1
To prevent the Control
results from being
included in the average, you
should mark each Control
Test with a “C.” This must
be done before performing
the Control Test.
First, insert the Test Strip fully
into the Meter.
2
A beep sounds and a full
display appears briefly.
The Function Number and
the previous test result begin
flashing alternately.
3
Pull out the Test Strip,
and immediately insert it
back into the Meter (within 2
seconds). A C- and the F#
begin flashing alternately in
the Display.
You can now run the Control
Test (see page 9).
Mark a Control Test Result SECTION 4