Filter
Top Products
11
3
Remove the Test Strip
from packet. Holding the
round end, insert the strip
fully into the Meter.
NOTE: Save the empty foil
packet for use in Step 6.
4
A beep sounds and a full
display appears, followed
by the Function Number (F#)
and the previous test result.
The Function Number and
the previous test result begin
flashing alternately.
If you are not using the
memory feature, go directly
to Step 6.
5
Mark your Control Test
result by pulling out the
Test Strip, and quickly insert-
ing it back into the Meter
(within 2 seconds). A C- and
the Function Number F#
begin flashing in the Display.
Marking a Control Test
excludes the Control Test
result from the average of
stored Blood Glucose Test
results.
The Control Test (continued) SECTION 2