Filter
Top Products
23
1
Insert the Check
Strip fully into the
Meter as shown.
NOTE: If your Check
Strip is not available,
you can use a new
Test Strip for this
procedure. However,
you have to wait 3
minutes for the
memory sequence
to begin.
2
A beep sounds
and a full display
appears briefly.
Another beep sounds
and the Check Strip
result is displayed.
Recall Test Results from the Memory SECTION 4
3
After 10 seconds,
the memory
sequence begins
automatically. An A-
(for average) appears
for 2 seconds, fol-
lowed by the average
test result value (for
4 seconds).
4
The memory
recall sequence
continues. The most
recent result is pre-
ceded by a 1- fol-
lowed by all other
stored results. The
last result displayed is
the oldest test result.
NOTE: If no values
are stored, three bars
––– appear after the
average A-.