Filter
Top Products
Section 1
General Information
1-4 General Information MN770
Caution: To prevent equipment damage, be certain that the electrical service
is not capable of delivering more than the maximum line short
circuit current amperes listed in the appropriate control manual, 230
VAC or 460 VAC maximum per control rating.
Caution: Disconnect motor leads (T1, T2 and T3) from control before you
perform a “Megger” test. Failure to disconnect motor from the
control will result in extensive damage to the control. The control is
tested at the factory for high voltage / leakage resistance as part of
Underwriter Laboratory requirements.