How do I prepare my system for the first time?
When you are setting up your receiver for the rst time, perform all of the procedures listed below in the
order that they are listed. Check each procedure o when you complete it.
o
Install batteries in the transmitter rst and then in the receiver (see Section 2).
o
Set the time and date (see Section 3).
o
Perform a control solution test (see Section 4).
o
Insert your sensor (see Section 5).
o
Attach your transmitter (see Section 6).
o
Calibrate your receiver when prompted (see Section 7).
o
Set the alarms in the receiver (see Section 8). Note: is can be done while waiting to perform the
rst calibration.
Result: Your system is operational.
Customer Care: 1-866-597-5520
6 Section 1
Getting Acquainted