Filter
Top Products
16
TID – single Transaction identifier bit, used in Write Config. Register Channel
Command.
SD - Status delay, 2 bit field used in Sync command. Allows return status data to be
delayed by up to 3 frames.
EL0s - The EL0s bit indicates the channel should transition from the L0 state to the L0s
state for exactly 42 frames. The L0 state is the state when the channel is ready to
accept Channel and DRAM commands. The L0s state is an optional state used in
systems that use power management.
ERC - The ERC bit indicates that the channel should transition from L0 state to
recalibrate state for exactly 42 frames. Used in Sync frame.
IER – This bit indicates that commands and CRC errors be ignored by the AMB until
after the next reset. Used in Sync frame.
A10:2 - Address bus for Read or Write configuration Channel Commands.
Default Trigger
When a configuration file is loaded the default trigger will be set to trigger the analyzer
when the Mode bit is = 0 and Frame = 1. When mode and frame are set at these values
the AMB will be done with training sequences and the data that is on the channel is
properly aligned and can be decoded properly by the decoder.