Filter
Top Products
11
The other orientation for the probe is with a 90 degree bend to either it’s front (AMB) or
back side. There are right angle brackets provided to keep the probe in this position
along with the associated nylon hardware. It is our recommendation that the interposed
FBDIMM be placed in the probe before the probe is bent over. This provides additional
stiffness at the FBDIMM straddle mount connector on the top of the probe.
The right angle brackets bend the probe in a “high” position which would allow a user to
place a second FS2343 Interposer in the slot next to it bent at a “lower” angle that would
allow the second probe to nest underneath the first probe bent and secured by the
brackets in the “high” position.
Be very careful when nesting 2 Interposer probes. Make sure there is good
ventilation for all the AMB chips and that the cables are not kinked or resting on
any sharp or hot objects.
External Power supply
The FS2343 Interposer probe requires the use an external DC power supply. This unit is
provided as part of the product and is required for the probe to operate. It is connected
to the probe with a mini plug. Do not use any other DC supply with the probe.