64
6.5 Log Settings (Syslog)
If you have a log server on your LAN, this screen allows you to configure the WAP-
4060PE to send log data to your log server.
Data - Log Settings Screen
Syslog Server
Select the desired Option:
· Disable - Syslog server is not used.
· Broadcast - Syslog data is broadcast. Use this
option if different PCs act as the Syslog server at dif-
ferent times.
· Send to specified Syslog Server - Select this if the
same PC is always used as the Syslog server. If se-
lected, you must enter the server address in the field
provided.
Syslog Server Address
Enter the name or IP address of your Syslog Server.
Minimum Severity
Level
Select the desired severity level. Events with a severity
level equal to or higher (i.e. lower number) than the
selected level will be logged.
6.6 Rogue APs
A "Rouge AP" is an Access Point which should not be in use, and so can be consid-
ered to be providing unauthorized access to your LAN.
This WAP-4060PE can assist to locate 2 types of Rogue APs:
· APs which have Wireless security disabled.
· APs which are not in the list of valid APs which you have entered.
When a Rogue AP is located, it is recorded in the log. If using SNMP, you can also
choose to have detection of a Rogue AP generate an SNMP trap.
