35
RTS/CTS Threshold
Enter the preferred setting between 256 and 2346. Nor-
mally, this can be left at the default value.
Preamble Type
Select the desired option. The default is "Long". The
"Short" setting takes less time when used in a good envi-
ronment.
Output Power Level
Select the desired power output. Higher levels will give a
greater range, but are also more likely to cause interfer-
ence with other devices.
Antenna Selection
WAP-4060PE has only 1 antenna, there is only 1 option
available.
802.11b
Protection Type
Select the desired option. The default is CTS-only.
Short Slot Time
Enable or disable this setting as required.
Protection Mode
The Protection system is intended to prevent older
802.11b devices from interfering with 802.11g transmis-
sions. (Older 802.11b devices may not be able to detect
that an 802.11g transmission is in progress.) Normally,
this should be left at "Auto".
Protection Rate
Select the desired option. The default is 11 Mbps.
