Data Entry 3-15
2325A137REFGD Revision B 2325 Reference Guide
Terminal Emulation
Note: Narrowband and spread spectrum 900MHz radios are not
supported at this time. For details concerning future
capabilities, contact the LXE Product Marketing department.
All terminal emulation radio controlled data flows and exchanges are
over the radio to the 64XX or 65XX units, then to the computer network
and then to a host computer. The LXE Network Management System, as
part of the wired network, can remotely configure the 2325’s terminal
emulation parameters.
Note: 2325’s with 64XX series 2.4GHz spread spectrum radios
communicate only with 64XX Access Points with installed
64XX 2.4GHz radios.
Note: 2325’s with 65XX series 2.4GHz spread spectrum radios
communicate only with 65XX Access Points with installed
65XX 2.4GHz radios.
Please refer to the system specific terminal emulation reference guide for
instruction when using a 2325 in a specific TE environment. A list of
LXE reference guides is located at the end of this chapter in the section
titled “Manuals.”
LXE’s terminal emulation programs that are compatible with the 2325
computer are:
ANSI Plus
Running on a 2325 with a 2.4GHz radio. ANSI Plus uses a Telnet
connection to communicate with the host computer. A 2325 with a
2.4GHz radio is interfaced to a computer network (Ethernet or Token-
Ring) via 2.4GHz radio equipped 64XX or 65XX Access Points. ANSI
Plus does not support Narrowband RF.
TN3270 TE and
TN5250 TE
Runs on a 2325 with a 64XX or 65XX series 2.4GHz radio. The TE
provides IBM host application support over the RF backbone and
TCP/IP network. SNA Server software running on an LXE 6600
Gateway provides TN services to the 2325 allowing it to communicate
