3-49CrossPoint 450 Plus and MAV Plus Switchers • Operation
Advanced features consist of:
Creating I/O groups
Setting RGB delay
Setting video and audio output mutes
Setting audio output volume
Setting the rear panel remote port protocol and baud rate
The switcher ships from the factory in Lock mode 2.
Selecting Lock mode 2 or toggling between mode 2 and mode 0
If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in Lock mode 2, this procedure selects mode 0 (unlocks the
switcher).
To toggle the lock on and off, press and hold the Enter button, the RGBHV
(CrossPoint 450 Plus) or Video (MAV Plus) button, and the Audio button for
approximately two seconds (figure 3-75).
I / O
VIDEO AUDIO
ENTER
I / O
VIDEO AUDIO
ENTER
ress and hold the Enter, RGBHV /Video, and Audio
uttons simultaneously to turn on Lock mode 2 or to
oggle between mode 2 and mode 0.
2 seconds
The Enter, RGBHV/ Video
and Audio buttons blink
twice to indicate the mode
change.
Release the buttons.
Figure 3-75 — Toggle front panel lock on (mode 2) or off (mode 0)
Selecting Lock mode 2 or toggling between mode 2 and mode 1
If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher in in Lock mode 2, this procedure selects mode 1.
To toggle the lock on and off, press and hold the RGBHV (CrossPoint 450 Plus) or
Video (MAV Plus) button and the Audio button for approximately two seconds
(figure 3-76).
I / O
VIDEO AUDIO
I / O
VIDEO AUDIO
ress and hold the RGBHV /Video and Audio
uttons simultaneously to turn on Lock mode 2
r to toggle between mode 1 and mode 2.
2 seconds
The RGBHV/ Video
and Audio buttons
blink twice to indicat
the mode change.
Release the buttons
Figure 3-76 — Toggle front panel lock between mode 2 and mode 1
