Installation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Installation2-16
Side
RJ-45
connector
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Insert
Twisted
Pair Wires
Figure 2-20 — RJ-45 connector and pinout tables
Reset button
1
Reset button — The Reset button initiates four levels of reset to the
matrix switcher. Press and hold the button while the switcher is
running or while you power up the switcher for different reset
levels.
See “Reset button” in chapter 3, “Operation”, for details.
• Events (mode 3) reset — Hold Reset for 3 seconds then release and push
again to toggle events monitoring on and off.
• IP settings (mode 4) reset — Hold Reset for 6 seconds then release and
push again to reset the switcher’s IP functions.
IP settings reset does not replace any user-installed firmware.
• Absolute (mode 5) reset — Hold Reset for 9 seconds then release and
push again to restore the switcher to the default factory conditions.
• Hard reset — Hold Reset while powering up the switcher to restore the
switcher to the default factory conditions.
Hard reset does not clear the current configuration.
RESE
