Matrix Software, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software5-2
Matrix Software
Matrix Switchers Control Program
The Windows-based Extron Matrix Switchers Control Program, which
communicates with the switcher via the rear panel Remote RS-232/RS-422 port, the
front panel Configuration (RS-232) port (matrix sizes up to 1616), and the LAN
port, provides an easy way to set up ties and sets of ties. The program is
compatible with Windows 2000 and Windows XP.
Installing the software
The program is contained on the Extron Software Products CD-ROM, disk B.
Install the software as follows:
For full functionality, install both of the following programs:
• The Matrix Switchers Control Program
• The Firmware Loader
1. Insert the CD-ROM into the drive. The installation program should start
automatically. If it does not self-start, run Launch.exe from the CD.
The Extron software CD window appears (figure 5-1).
Figure 5-1 — Software CD window
2. Click the Software tab (figure 5-1).
3. Scroll to the desired program and click Install (figure 5-2).
Figure 5-2 — Software installation
